Description What makes the TST genuinely versatile is the interface for an external transducer. This interface, accessed by a 2 way switch on the TST, allows the connection of any transducer from Norbar’s Smart range and most mV/V calibrated transducers from Norbar or other manufacturers. Pictorial display panel for easy mode selection Limit detection with low, pass and fail indication. Up to 8 target values can be set Digital limit state output for control of external tools Operation from fast charge internal battery pack (maximum time of 3 hours 20 minutes for full charge) or a.c. supply (90 to 264 Volts) RS-232-C serial data interface for connection to a printer or PC. Continuous RS 232 output when used in track mode (up to 11 readings per second) Pulse count feature in Impulse mode and Clutch Tool mode Smart intelligence for transducer recognition Memory for calibration details of 20 non-Smart mV/V calibrated transducers Analogue output allows the instrument to be used as part of a process control system for performance analysis User-selectable frequency response for each mode of operation All user-selectable features have password protection. The instrument can be issued to users with only the required modes of operation and units of measure enabled. This feature can virtually eliminate operator induced errors 1/4″ female hex to 1/4″ female square adaptor comes supplied as standard TST SERIES 2 43212: TST 2, 0.04 – 2 N.m 43213: TST 10, 0.5 – 10 N.m 43214: TST 25, 1.25 – 25 N.m TST.CCW: Counter-clockwise calibration when ordered with new unit Above part numbers exclude Transducer lead for external transducer TST is supplied complete with a Rundown Fixture for joint simulation.
