Transtar TexCoat Chipguard Black . Flexible protective Coating 4313

Description Transtar TexCoat Chipguard Black 4313. Flexible protective Coating   Tex Coat is a flexible protective coating. Texture can be varied to match OEM textures as found on rocker panels, valances, etc. Suitable Substrates • Raw plastic – rigid (SMC, BMC) • Bare steel • 1K primer • Raw plastic – flex (ABD, PPO) • Bare galvanized • 2K primer • Raw plastic – soft (PUR) • Bare aluminum • Self etch primer • Plastic part- primed • OEM E-coat • Body filler • OEM finish & old paint work – non-reversible Features Tex Coat is a rapid drying, flexible protective coating. Texture can be varied to match OEM textures as found on rocker panels, valances, etc. Paintable in 30-45 minutes. Highly chip resistant. Convenient aerosol requires no equipment clean-up. Surface Prep & Application Clean with wax and grease remover.  Remove existing finish and clean again with wax and grease remover. Prepare bare metal with appropriate Transtar metal primer. Sand with 220grit.  Remove sanding dust with Wax and grease.  Shake Tex Coat can vigorously.  Apply in 1 – 3 light even coats.  Film build should be about 3.0mils per coat.  Total film build should not exceed 8-10 mils. Flash 10-15 minutes between coats. IMPORTANT: KEEP CAN IN MOTION WHEN APPLYING TO AVOID EXCESSIVE FILM BUILD. Allow final Tex Coat application to flash 30-60 minutes at 75°F (25°C) before topcoating. Follow manufacturer’s instructions before topcoating. Flash Times/Dry Times Flash time …………………….10 – 15 min @ 70°F (21°C)   For more information in relation to the product view the Technical Data Sheet below- http://www.sapegroup.com.au/uploads/sds/TS4313.pdf